Projects

We are succesfully completed 200 projects and describe some major projects below.

Stude and Seal Height Checking Machine.

This is assembly and checking machine.
Seal machine is done on that machine.
Seal and stude height should be check very precisely.
Component should be transfer by pick and place arrangement to the next station.
Machine is fully automated.
Operator only used to press BI - Manual start button.

Machine Specification

M/C overall size :- length : 1100, width : 700, height : 2280v.
Loading height :- 1000 mm.
Job loading / unloading :- manually.
Type of Machine :- seal assembly, stud height & seal height checking machine.
Supply pressure :- Minimum 5 bar.
Electrical supply :- 230 V AC, single phase.
Cycle of operations :- Manually thru push buttons ( bi-manual start ).
Operation of machine :- Thru, Pneumatic cylinders.
Machine Cycle time :- 20 sec excluding load / unload appro. May vary at actual.


Head Rod Setting Machines

Description

This is head rod setting machine.
Pneumatics cylinder and Pneumatic arrangement is to be used.

Machine Specification

M/C overall size :- length : 900, width : 860, height : 2300.
Job Loading height :- 1050 mm.
Job loading / unloading :- manually.
Type of Machine :- assembly machine.
Supply pressure :- Minimum 5 bar.
Electrical supply :- 230 V AC, single phase.
Cycle of operations :- Manually thru push buttons ( bi-manual start ).
Operation of machine :- Thru, Pneumatic cylinders.
Machine Cycle time :- 20 sec excluding load / unload appro. May vary at actual.


Trimming machine

Description

This is a trimming of bajaj pulsor 400 tail light component machine.
Casting component should be trim to their parts happen at the time of casting.
Drilling should be done on that machine.

Machine Specification

M/C overall size :- length : 2000 MM, width : 800 MM, height : 2100MM
Job Loading height :- 1050 mm.
Job loading / unloading :- manually.
Type of Machine :- Trimming Machine and Drilling Machine.
Supply pressure :- Minimum 50 bar.
Electrical supply :- 230 V AC, single phase.
Cycle of operations :- Manually thru push buttons ( bi-manual start ).
Operation of machine :- Thru, Power Pack Hydrolic cylinders.
Machine Cycle time :- 25 sec excluding load/unload appro. May vary at actual.